Xerox Phaser 6180MFP - Out of Memory;Hard Drive Full

Phaser 6180MFP Multifunction Printer Service Manual 3-99
Error Messages and Codes
Out of Memory/Hard Drive Full
The printer memory is full and cannot continue to print. Print job requires
additional memory. The following troubleshooting procedure applies to these
errors.
Applicable Chain Link
■ Chain Link 016-718: Out of memory
■ Chain Link 016-982: Hard Drive Full (Disk Full)
Initial Actions
■ Cycle printer power.
■ If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ Image Processor Board, PL9.1.20
■ Memory Card (Option), PL9.1.22
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 1.Check the required memory for the
print job.
2.Print a small size file (example as a
Windows test print).
3.Does the error still occur?
Go to step 2. Add memory
card or separate
the print job.
2 1.Reseat the memory card
(page 8-94).
2.Does the error still occur?
Go to step 3. Complete.
3 1.Check the memory card capacity.
Print the printer Configuration Page:
System > Information Pages >
Configuration.
2.Does the memory meet the print job
requirements?
Go to step 4. Replace the
Image
Processor
Board
(page 8-90).
4 1.Replace the memory card
(page 8-94).
2.Does the error still occur?
Replace the
Image
Processor Board
(page 8-90).
Complete.