Phaser 6180MFP Multifunction Printer Service Manual 6-5
Adjustments and Calibrations
Resetting the Fuser
Fuser reset is required when a new Fuser is installed into the printer. This
function sets the life counter to “0.”
1. From the Control Panel, press the System button.
2. Press the Up Arrow or Down Arrow button to find Admin Menu. Press
the OK button.
3. Press the Up Arrow or Down Arrow button to find Maintenance. Press
the OK button.
4. Press the Up Arrow or Down Arrow button to find Reset Fuser. Press
the OK button.
5. Are You Sure? message is displayed. Select Yes and press the OK
button to start the process.
6. The Maintenance - Reset Fuser menu is displayed when the process is
completed.
To Next Page
Loading...
