Xerox Phaser 6180MFP - ADC Sensor Error (Error Code 01)

Phaser 6180MFP Multifunction Printer Service Manual 3-139
Error Messages and Codes
ADC Sensor Error (Error Code 01)
The ADC Sensor has detected density error. The following troubleshooting
procedure applies to this error.
Applicable Chain Link
■ Chain Link 092-651: ADC Sensor Error (IOT ADC Sensor Error) (Error
Code 01)
Initial Actions
■ Ensure the Transfer Unit and surrounding area is free of waste toner.
■ Cycle printer power.
■ If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ Front Cover Harness, PL1.2.13
■ Transfer Unit, PL4.1.1
■ Print Cartridge (C/M/Y/K),
PL5.1.17-20
■ MCU Board, PL9.2.13
■ Right Side Harness, PL10.1.12
■ “Map 1 - Electrical and Drive” on
page 10-10
■ “Map 4 - LVPS and MCU Board” on
page 10-13
■ “Xerographic” on page 10-34
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 1.Check the Transfer Unit for correct
installation.
2.Is the Transfer Unit correctly
installed?
Go to step 3. Reseat the
Transfer Unit
(page 8-9).
Go to step 2.
2 Does the error still occur when the
printer is turned On?
Go to step 3. Complete.
3 Check the toner density and compare
the density of four colors toner.
1.Perform Gradation Test Print
(page 5-16): Service Mode >
Printer Diag > Test Print >
Gradation ESS.
2.Is there dark color on the print?
Go to step 4. Replace the
MCU Board
(page 8-88).