3-150 Phaser 6180MFP Multifunction Printer Service Manual
Error Messages and Codes
NVRAM Error
The printer controller has detected NVRAM error. The following
troubleshooting procedure applies to these errors.
Applicable Chain Link
■ Chain Link 116-323: NVRAM Error (NVRAM1 W/R Check Fail)
■ Chain Link 116-326: NVRAM Error (NVRAM2 W/R Check Fail)
■ Chain Link 116-390: NVRAM Error (NVRAM1 Size and ID Check Fail)
Initial Actions
■ Cycle printer power.
■ If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ Image Processor Board, PL9.1.20
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 1.Check the Image Processor Board
for correct installation.
2.Is the Image Processor Board
correctly installed?
Go to step 2. Reseat the
Image
Processor
Board
(page 8-90).
2 Does the error still occur when the
printer is turned On?
Replace the
Image
Processor Board
(page 8-90).
Complete.
To Next Page
Loading...
