Phaser 6180MFP Multifunction Printer Service Manual 3-97
Error Messages and Codes
Control Panel Language Set Unsupported
The Control Panel does not support the language. The following
troubleshooting procedure applies to this error.
Applicable Chain Link
■ Chain Link 016-610: Panel Language Set unsupported
Initial Actions
■ Cycle printer power.
■ If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ MCU Board, PL9.2.13
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 1.Turn the printer power Off and back
On.
2.Does the error still occur?
Replace the
MCU Board
(page 8-88).
Complete.
To Next Page
Loading...
