Xerox Phaser 6180MFP - Fax Errors; Memory Full

3-184 Phaser 6180MFP Multifunction Printer Service Manual
Error Messages and Codes
Fax Errors
Memory Full
The Scanner Controller Board does not have enough memory allocation. The
following troubleshooting procedure applies to these errors.
Applicable Chain Link
■ Chain Link 017-970: Memory Full (AIOC Lack of Memory)
■ Chain Link 033-503: Memory Full
Initial Actions
■ Cycle printer power.
■ If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ Scanner Controller Board, PL9.1.1
■ ADF Scanner Assembly, PL11.1.1
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 1.Turn the printer power Off and back
On.
2.Does the error still occur when
receiving fax?
Go to step 2. Complete.
2 1.Check the stored data on the printer:
System > Information Pages >
Stored Documents.
2.Are there any stored data?
■ For the
Delayed Start,
wait until the
data will be sent.
■ For the
Delayed Print,
print the stored
data.
■ For the Secure
Receive, enter
password to
print.
Go to step 3.