Xerox Phaser 6180MFP - Ordering Supplies; Consumables; Routine Maintenance Items

Phaser 6180MFP Multifunction Printer Service Manual 3-41
Error Messages and Codes
29 Check the Right Side Harness for
continuity.
1.Disconnect P/J25 from the MCU
Board.
2.Disconnect P/J251 from the Feed
Drive Assembly.
3.Check continuity between P/J25 <=>
P/J251.
Go to step 30. Replace the
Right Side
Harness.
30 Check the Feed Drive Assembly signal.
1.Disconnect P/J25 from the MCU
Board.
2.Is there +24 V across ground <=>
J25-1/J25-2 pin on the MCU Board
when the Interlock Switch is
activated?
Replace the
Feed Drive
Assembly
(page 8-78).
Replace the
MCU Board
(page 8-88).
31 1. Check the wiring harness
connectors P/J23 and P/J233
between the MCU Board and the
Registration Clutch.
2.Are the connectors securely
connected?
Go to step 32. Reconnect the
connectors.
32 Check the Right Side Harness
continuity.
1.Disconnect P/J23 from the MCU
Board.
2.Disconnect P/J233 from the
Registration Clutch.
3.Check continuity between P/J23 <=>
P/J233.
Go to step 33. Replace the
Right Side
Harness.
33 Check the Registration Clutch signal.
1.Disconnect P/J23 from the MCU
Board.
2.Is there +24 V across ground <=>
J23-11 pin on the MCU Board when
the Interlock Switch is activated?
Replace
Registration
Clutch
(page 8-45).
Replace the
MCU Board
(page 8-88).
Troubleshooting Procedure Table (continued)
Step Actions and Questions Yes No