Xerox Phaser 6180MFP - Page 323

Phaser 6180MFP Multifunction Printer Service Manual 3-135
Error Messages and Codes
5 1.Check the Main Drive Assembly for
correct installation.
2.Is the Main Drive Assembly
correctly installed?
Go to step 6. Reseat the Main
Drive Assembly
(page 8-75).
6 Does the error still occur when the
printer is turned On?
Go to step 7. Complete.
7 1.Check the wiring harness
connectors P/J22 and P/J222
between the MCU Board and the
Main Drive Assembly.
2.Are the connectors securely
connected?
Go to step 8. Reconnect the
connectors.
8 Check the Right Side Harness for
continuity.
1.Disconnect P/J22 from the MCU
Board.
2.Disconnect P/J222 from the Main
Drive Assembly.
3.Check continuity between P/J22 <=>
P/J252.
Go to step 9. Replace the
Right Side
Harness.
9 Check the Main Drive Assembly signal.
1.Disconnect P/J22 from the MCU
Board.
2.Is there +24 V across ground <=>
J22-B2/J22-B4 pin when the
Interlock Switch is activated?
Replace the
Main Drive
Assembly
(page 8-75).
Replace the
MCU Board
(page 8-88).
Troubleshooting Procedure Table (continued)
Step Actions and Questions Yes No