Phaser 6180MFP Multifunction Printer Service Manual 8-43
Service Parts Disassembly
10. Close the Front Door (this will provide easier access to the Roll). Remove
the E-ring securing the bearing on the left and right sides of the Roll, and
shift the bearing toward the inside.
11. Shift the Roll to the right and pull out the left side shaft section of the Roll
from the bearing. Pull the Tray 1 (MPT) Roll out toward the lower left side
to remove it.
Caution
Be careful not to drop and lose the Earth Bearing (black) and the Bearing
(white).
12. Remove the Earth Bearing from the Tray 1 (MPT) Roll.
ep
acemen
o
e
ep
acemen
o
e
Pay attention to the orientation of the Bearings. The right side of the
Earth Bearing (PL3.1.6) is Black; the left side of the Bearing
(PL3.1.13) is White.
Be sure the D cut surface of the Shaft faces upward which makes the
installation process easier.
Attach the elliptical side of the mounting section of the MPT Feed
Spring to the Gear.
s6180mfp-267
White
Black
To Next Page
Loading...
