AudioCodes E-SBC User Manual

CHAPTER58 Syslog and Debug Recording
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
■ [3] Trunk Group ID = Filters log by Trunk Group ID. To
configure Trunk Groups, see Configuring Trunk Groups.
Note: Applicable only to the Gateway application.
■ [4] Trunk & B-channel = Filters log by Trunk and B-channel.
Note: Applicable only to the Gateway application.
■ [5] FXS or FXO = Filters log by FXS or FXO port.
Note: Applicable only to the Gateway application.
■ [6] Tel-to-IP = Filters log by Tel-to-IP routing rule. To configure
Tel-to-IP routing rules, see Configuring Tel-to-IP Routing Rules.
Note: Applicable only to the Gateway application.
■ [7] IP-to-Tel = Filters log by IP-to-Tel routing rule. To configure
IP-to-Tel routing rules, see Configuring IP-to-Tel Routing Rules.
Note: Applicable only to the Gateway application.
■ [8] IP Group = Filters log by IP Group. To configure IP Groups,
see Configuring IP Groups.
■ [9] SRD = Filters log by SRD. To configure SRDs, see
Configuring SRDs.
■ [10] Classification = Filters log by Classification rule. To
configure Classification rules, see Configuring Classification
Rules.
Note: Applicable only to the SBC application.
■ [11] IP-to-IP Routing = Filters log by IP-to-IP routing rule. To
configure IP-to-IP routing rules, see Configuring SBC IP-to-IP
Routing Rules.
Note: Applicable only to the SBC application.
■ [12] User = Filters log by user. The user is defined by username
or username@hostname in the Request-URI of the SIP
Request-Line. For example, "2222@10.33.45.201", which
represents the following INVITE:
INVITE sip:2222@10.33.45.201;user=phone SIP/2.0
■ [13] IP Trace = Filters log by an IP network trace, Wireshark-
like expression. For more information, see Filtering IP Network
Traces.
■ [14] SIP Interface = Filters log by SIP Interface. To configure
SIP Interfaces, see Configuring SIP Interfaces.
'Value'
value
[LoggingFilters_Value]
Defines the value for the filtering type configured in the 'Filter Type'
parameter.
The value can include the following:
■ A single value.
■ A range, using a hyphen "-" between the two values. For
example, to specify IP Groups 1, 2 and 3, configure the
parameter to "1-3" (without apostrophes).
■ Multiple, non-contiguous values, using commas "," between
each value. For example, to specify IP Groups 1, 3 and 9,
configure the parameter to "1,3,9" (without apostrophes).
■ Trunks, FXS, or FXO pertaining to a module, using the syntax
module number/port or port, for example:
- 1036 -

AudioCodes E-SBC Specifications

General

Brand	AudioCodes
Model	E-SBC
Category	Gateway
Language	English