AudioCodes E-SBC User Manual

CHAPTER68 Configuration Parameters Reference
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
[SendISDNServiceAfterRe
start]
configure voip >
sip-definition
proxy-and-
registration >
redirect-in-
facility
[SupportRedirectInFacility]
Determines whether the Redirect Number is retrieved from the
Facility IE.
■ [0] = (Default) Not supported.
■ [1] = Supports partial retrieval of Redirect Number (number
only) from the Facility IE in ISDN Setup messages. This is
applicable to Redirect Number according to ECMA-173 Call
Diversion Supplementary Services.
Note: To enable this feature, the parameter
ISDNDuplicateQ931BuffMode must be set to 1.
[EnableCIC] Enables the relay of the Carrier Identification Code (CIC) to the
ISDN.
■ [0] = (Default) Disabled - CIC is not relayed to the ISDN.
■ [1] = Enabled - CIC (received in the INVITE Request-URI) is
relayed to the ISDN in the Transit Network Selection (TNS)
IE of the Setup message. For example: INVITE
sip:555666;cic=2345@100.2.3.4 sip/2.0.
Note:
■ This feature is supported only for SIP-to-ISDN calls.
■ The parameter AddCicAsPrefix can be used to add the CIC
as a prefix to the destination phone number for routing IP-to-
Tel calls.
'AoC Support'
configure voip >
gateway dtmf-supp-
service supp-
service-settings >
aoc-support
[EnableAOC]
Enables the interworking of ISDN Advice of Charge (AOC)
messages to SIP.
■ [0] Disable (default)
■ [1] Enable
For more information on AOC, see Advice of Charge Services
for Euro ISDN.
'Add IE in SETUP'
add-ie-in-setup
[AddIEinSetup]
Global parameter that defines an optional Information Element
(IE) data (in hex format) to add to ISDN Setup messages. You
can also configure this feature per specific calls, using IP
Profiles (IpProfile_AddIEInSetup). For a detailed description of
the parameter and for configuring this feature in the IP Profiles
table, see Configuring IP Profiles.
Note: If this feature is configured for a specific IP Profile, the
settings of this global parameter is ignored for calls associated
with the IP Profile.
'Trunk Groups to Send IE'
trkgrps-to-snd-ie
[SendIEonTG]
Defines Trunk Group IDs (up to 50 characters) from where the
optional ISDN IE (defined by the parameter AddIEinSetup) is
sent. For example: '1,2,4,10,12,6'.
Note:
- 1286 -

AudioCodes E-SBC Specifications

General

Brand	AudioCodes
Model	E-SBC
Category	Gateway
Language	English