EasyManuals Logo

AudioCodes E-SBC User Manual

AudioCodes E-SBC
1414 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1325 background imageLoading...
Page #1325 background image
CHAPTER68 Configuration Parameters Reference
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
â–  You can configure different IE data for Trunk Groups by
defining the parameter for different IP Profile IDs (using the
parameter IPProfile), and then assigning the required IP
Profile ID in the IP-to-Tel Routing table (PSTNPrefix).
â–  When IP Profiles are used for configuring different IE data
for Trunk Groups, the parameter is ignored.
'Enable User-to-User IE for
Tel to IP'
uui-ie-for-tel2ip
[EnableUUITel2IP]
Enables transfer of User-to-User (UU) IE from ISDN to SIP.
â–  [0] Disable (default)
â–  [1] Enable
The device supports the following ISDN-to-SIP interworking:
Setup to SIP INVITE, Connect to SIP 200 OK, User Information
to SIP INFO, Alerting to SIP 18x response, and Disconnect to
SIP BYE response messages.
Note: The interworking of ISDN User-to-User IE to SIP INFO is
applicable only to the Euro ISDN, QSIG, and 4ESS ISDN
variants.
'Enable User-to-User IE for
IP to Tel'
uui-ie-for-ip2tel
[EnableUUIIP2Tel]
Enables interworking of SIP user-to-user information (UUI) to
User-to-User IE in ISDN Q.931 messages.
â–  [0] Disable = (Default) Received UUI is not sent in ISDN
message.
â–  [1] Enable = The device interworks UUI from SIP to ISDN
messages. The device supports the following SIP-to-ISDN
interworking of UUI:
✔ SIP INVITE to Q.931 Setup
✔ SIP REFER to Q.931 Setup
✔ SIP 200 OK to Q.931 Connect
✔ SIP INFO to Q.931 User Information
✔ SIP 18x to Q.931 Alerting
✔ SIP BYE to Q.931 Disconnect
Note:
â–  The interworking of ISDN User-to-User IE to SIP INFO is
applicable only to the Euro ISDN, QSIG, and 4ESS ISDN
variants.
â–  To interwork the UUIE header from SIP-to-ISDN messages
with the 4ESS ISDN variant, the ISDNGeneralCCBehavior
parameter must be set to 16384.
[Enable911LocationIdIP2T
el]
Enables interworking of Emergency Location Identification from
SIP to PRI.
â–  [0] = Disabled (default)
â–  [1] = Enabled
When enabled, the From header received in the SIP INVITE is
translated into the following ISDN IE's:
â–  Emergency Call Control.
â–  Generic Information - to carry the Location Identification
Number information.
- 1287 -

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AudioCodes E-SBC and is the answer not in the manual?

AudioCodes E-SBC Specifications

General IconGeneral
BrandAudioCodes
ModelE-SBC
CategoryGateway
LanguageEnglish

Related product manuals