EasyManua.ls Logo

AudioCodes E-SBC - Page 1326

AudioCodes E-SBC
1414 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CHAPTER68 Configuration Parameters Reference
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
Generic Information - to carry the Calling Geodetic Location
information.
Note: The parameter is applicable only to the NI-2 ISDN
variant.
early-answer-
timeout
[EarlyAnswerTimeout]
Global parameter that defines the duration (in seconds) that the
device waits for an ISDN Connect message from the called
party (Tel side), started from when it sends a Setup message.
You can also configure this feature per specific calls, using IP
Profiles (IpProfile_EarlyAnswerTimeout). For a detailed
description of the parameter and for configuring this feature in
the IP Profiles table, see Configuring IP Profiles.
Note: If this feature is configured for a specific IP Profile, the
settings of this global parameter is ignored for calls associated
with the IP Profile.
'Trunk Transfer Mode'
configure voip >
interface e1-t1|bri
> trk-xfer-mode-
type
[TrunkTransferMode]
Determines the trunk transfer method (for all trunks) when a SIP
REFER message is received. The transfer method depends on
the Trunk's PSTN protocol (configured by the parameter
ProtocolType) and is applicable only when one of these
protocols are used:
PSTN Protocol Transfer Method (Described
Below)
E1 Euro ISDN [1] ECT [2] or InBand [5]
E1 QSIG [21],
T1 QSIG [23]
Single Step Transfer [4], Path
Replacement Transfer [2], or
InBand [5]
T1 NI2 ISDN [10],
T1 4ESS ISDN [11],
T1 5ESS 9 ISDN [12]
TBCT [2] or InBand [5]
T1 DMS-100 ISDN [14] RTL [2] or InBand [5]
T1 RAW CAS [3], T1
CAS [2], E1 CAS [8], E1
RAW CAS [9]
[1] CAS NFA DMS-100 or [3]
CAS Normal transfer
T1 DMS-100 Meridian
ISDN [35]
RTL [2] or InBand [5]
The valid values of the parameter are described below:
[0] = Not supported (default).
[1] = Supports CAS NFA DMS-100 transfer. When a SIP
REFER message is received, the device performs a Blind
Transfer by executing a CAS Wink, waits for an
acknowledged Wink from the remote side, dials the Refer-to
number to the switch, and then releases the call.
Note: A specific NFA CAS table is required.
- 1288 -

Table of Contents

Related product manuals