AudioCodes E-SBC User Manual

CHAPTER68 Configuration Parameters Reference
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
■ [-1] Not Configured = (Default) Not
configured (interworking from ISDN to
IP) or set to 0 for CAS.
■ [0] User Provided = CPN set by user,
but not screened (verified).
■ [1] User Passed = CPN set by user,
verified and passed.
■ [2] User Failed = CPN set by user, and
verification failed.
■ [3] Network Provided = CPN set by
network.
Note:
■ The parameter is applicable only if the
Remote Party ID (RPID) header is
enabled.
■ The parameter is applicable only to
digital interfaces.
'Send Screening Indicator to ISDN'
[ScreeningInd2ISDN]
Overrides the screening indicator of the
calling party's number for IP-to-Tel ISDN
calls.
■ [-1] Not Configured = (Default) Not
configured (interworking from IP to
ISDN).
■ [0] User Provided = user provided, not
screened.
■ [1] User Passed = user provided,
verified and passed.
■ [2] User Failed = user provided, verified
and failed.
■ [3] Network Provided = network
provided
Note: The parameter is applicable only to
digital interfaces.
'Copy Destination Number to Redirect Number'
cp-dst-nb-2-redir-nb
[CopyDest2RedirectNumber]
Enables the device to copy the called
number (from the received ISDN message
for digital interfaces) to the outgoing SIP
Diversion header for Tel-to-IP calls (even if a
Redirecting Number IE is not received in the
ISDN Setup message for digital interfaces).
Therefore, the called number is used as a
redirect number. Call redirection information
is typically used for Unified Messaging and
voice mail services to identify the recipient
of a message.
■ [0] Don't copy = (Default) Disable.
- 1321 -

AudioCodes E-SBC Specifications

General

Brand	AudioCodes
Model	E-SBC
Category	Gateway
Language	English