AudioCodes E-SBC User Manual

CHAPTER68 Configuration Parameters Reference
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
Note: The parameter is applicable only to
digital interfaces.
configure voip > gateway
manipulation settings > use-
refer-by-for-calling-num
[UseReferredByForCallingNumber]
Determines whether the device uses the
number from the URI in the SIP Referred-By
header as the calling number in the outgoing
Q.931 Setup message, when SIP REFER
messages are received.
■ [0] = (Default) No
■ [1] = Yes
Note:
■ The parameter is applicable to all ISDN
(TBCT, RLT, ECT) and CAS blind call
transfers (except for in-band) and when
the device receives SIP REFER
messages with a Referred-By header.
■ This manipulation is done before regular
IP-to-Tel source number manipulation.
■ The parameter is applicable only to
digital interfaces.
configure voip > gateway
manipulation settings > swap-tel-
to-ip-phone-num
[SwapTel2IPCalled&CallingNumbers]
Global parameter enabling the device to
swap the calling and called numbers
received from the Tel side (for Tel-to-IP
calls).
You can also configure the feature per
specific calls, using Tel Profiles (TelProfile_
SwapTelToIpPhoneNumbers). For a
detailed description of the parameter and for
configuring the feature in the Tel Profiles
table, see Configuring Tel Profiles.
Note: If the feature is configured for a
specific Tel Profile, the settings of the global
parameter is ignored for calls associated
with the Tel Profile.
'Add Prefix to Redirect Number'
add-pref-to-redir-nb
[Prefix2RedirectNumber]
Defines a string prefix that is added to the
Redirect number received from the Tel side.
This prefix is added to the Redirect Number
in the SIP Diversion header.
The valid range is an 8-character string. By
default, no value is defined.
Note: The parameter is applicable only to
digital interfaces.
'Add Number Plan and Type to RPI Header'
np-n-type-to-rpi-hdr
[AddTON2RPI]
Determines whether the TON/PLAN
parameters are included in the Remote-
Party-ID (RPID) header.
■ [0] No
■ [1] Yes (default)
- 1326 -

AudioCodes E-SBC Specifications

General

Brand	AudioCodes
Model	E-SBC
Category	Gateway
Language	English