AudioCodes E-SBC User Manual

CHAPTER68 Configuration Parameters Reference
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
If the Remote-Party-ID header is enabled
(EnableRPIHeader = 1) and AddTON2RPI =
1, it's possible to configure the calling and
called number type and number plan using
the Number Manipulation tables for Tel-to-IP
calls.
'Source Manipulation Mode'
configure voip > gateway routing
settings > src-manipulation
[SourceManipulationMode]
Determines the SIP headers containing the
source number after manipulation:
■ [0] From and P-Asserted-Identity after
Manipulation = (Default) The SIP From
and P-Asserted-Identity headers contain
the source number after manipulation.
■ [1] Only From after Manipulation =
Only SIP From header contains the
source number after manipulation, while
the P-Asserted-Identity header contains
the source number before manipulation.
configure voip > gateway
manipulation settings > prfm-ip-
to-tel-dst-map
[PerformAdditionalIP2TELDestinationManipula
tion]
Enables additional destination number
manipulation for IP-to-Tel calls. The
additional manipulation is done on the
initially manipulated destination number, and
this additional rule is also configured in the
manipulation table (NumberMapIP2Tel
parameter). This enables you to configure
only a few manipulation rules for complex
number manipulation requirements (that
generally require many rules).
■ [0] = Disable (default)
■ [1] = Enable
configure voip > gateway
manipulation settings > prfm-ip-
to-tel-src-map
[PerformAdditionalIP2TELSourceManipulation]
Enables additional source number
manipulation for IP-to-Tel calls. The
additional manipulation is done on the
initially manipulated source number, and this
additional rule is also configured in the
manipulation table
(SourceNumberMapIP2Tel parameter). This
enables you to configure only a few
manipulation rules for complex number
manipulation requirements (that generally
require many rules).
■ [0] = Disable (default)
■ [1] = Enable
'Add Phone Context As Prefix'
configure voip > gateway
manipulation settings > add-ph-
cntxt-as-pref
[AddPhoneContextAsPrefix]
Determines whether the received Phone-
Context parameter is added as a prefix to
the outgoing called and calling numbers (in
ISDN Setup messages for digital
interfaces).
■ [0] Disable (default)
- 1327 -

AudioCodes E-SBC Specifications

General

Brand	AudioCodes
Model	E-SBC
Category	Gateway
Language	English