AudioCodes E-SBC User Manual

CHAPTER68 Configuration Parameters Reference
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
configure voip > sbc settings >
sbc-3xx-bhvt
[SBC3xxBehavior]
Global parameter that defines the handling
of SIP 3xx redirect responses. You can also
configure this feature per specific calls,
using IP Profiles (IpProfile_
SBCRemote3xxBehavior). For a detailed
description of the parameter and for
configuring this feature in the IP Profiles
table, see Configuring IP Profiles.
Note: If this feature is configured for a
specific IP Profile, the settings of this global
parameter is ignored for calls associated
with the IP Profile.
configure voip > sbc settings >
enforce-media-order
[SBCEnforceMediaOrder]
Enables the device to include all previously
negotiated media lines within the current
session ('m=' line) in the SDP offer-answer
exchange (RFC 3264).
■ [0] = (Default) Disable
■ [1] = Enable
For example, assume a call (audio) has
been established between two endpoints
and one endpoint wants to subsequently
send an image in the same call session. If
the parameter is enabled, the endpoint
includes the previously negotiated media
type (i.e., audio) with the new negotiated
media type (i.e., image) in its SDP offer:
v=0
o=bob 2890844730 2890844731 IN
IP4 host.example.com
s=
c=IN IP4 host.example.com
t=0 0
m=audio 0 RTP/AVP 0
m=image 12345 udptl t38
If the parameter is disabled, the only ‘m=’
line included in the SDP is the newly
negotiated media (i.e., image).
'SBC Diversion URI Type'
configure voip > sbc settings >
sbc-diversion-uri-type
[SBCDiversionUriType]
Defines the URI type to use in the SIP
Diversion header of the outgoing SIP
message.
■ [0] Transparent = (Default) The device
does not change the URI and leaves it
as is.
■ [1] Sip = The "sip" URI is used.
■ [2] Tel = The "tel" URI is used.
- 1346 -

AudioCodes E-SBC Specifications

General

Brand	AudioCodes
Model	E-SBC
Category	Gateway
Language	English