AudioCodes E-SBC User Manual

CHAPTER18 Core Entities
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
✔ The IP Group cannot be defined as a User-type
since the SIP Contact header of the incoming
REGISTER does not represent a specific user.
The Request-URI user part can change and
therefore, the device is unable to identify an
already registered user and therefore, adds an
additional record to the database.
The IP address of the Gateway-type IP Group is
obtained dynamically from the host part of the
Contact header in the REGISTER request received
from the IP Group. Therefore, routing to this IP Group
is possible only once a REGISTER request is
received (i.e., IP Group is registered with the
device). If a REGISTER refresh request arrives, the
device updates the new location (i.e., IP address) of
the IP Group. If the REGISTER fails, no update is
performed. If an UN-REGISTER request arrives, the
IP address associated with the IP Group is deleted
and therefore, no routing to the IP Group is done.
You can view the registration status of the Gateway-
type IP Group in the 'GW Group Registered Status'
field, and view the IP address of the IP Group in the
'GW Group Registered IP Address' field if it is
registered with the device.
'Proxy Set'
proxy-set-name
[IPGroup_ProxySetName]
Assigns a Proxy Set to the IP Group. All INVITE
messages destined to the IP Group are sent to the IP
address configured for the Proxy Set.
To configure Proxy Sets, see Configuring Proxy Sets.
Note:
■ For the Gateway application, IP Group ID 0 cannot
be associated with Proxy Set ID 0.
■ The Proxy Set must be associated with the same
SRD as that assigned to the IP Group.
■ You can assign the same Proxy Set to multiple IP
Groups.
■ For the SBC application: Proxy Sets are used for
Server-type IP Groups, but may in certain scenarios
also be used for User-type IP Groups. For example,
this is required in deployments where the device
mediates between an IP PBX and a SIP Trunk, and
the SIP Trunk requires SIP registration for each user
that requires service. In such a scenario, the device
must register all the users to the SIP Trunk on behalf
of the IP PBX. This is done by using the User
Information table, where each user is associated
with the source IP Group (i.e., the IP PBX). To
configure the User Information table, see SBC User
Information for SBC User Database.
■ For the Gateway application, Proxy Sets are
applicable only to Sever-type IP Groups.
- 347 -

AudioCodes E-SBC Specifications

General

Brand	AudioCodes
Model	E-SBC
Category	Gateway
Language	English