AudioCodes E-SBC

CHAPTER18 Core Entities
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
■ "Connected": Keep-alive success (i.e., connectivity
with the IP Group).
The connectivity status is also displayed in the Topology
View page (see Building and Viewing SIP Entities in
Topology View).
Note:
■ The feature is applicable only to Server-type IP
Groups.
■ To support the feature, you must enable the keep-
alive mechanism of the Proxy Set that is associated
with the IP Group (see Configuring Proxy Sets).
■ If the Proxy Set is configured with multiple proxies
(addresses) and at least one of them is "alive", the
displayed status is "Connected". To view the
connected proxy server, see Viewing Proxy Set
Status.
■ The "Connected" status also applies to scenarios
where the device rejects calls with the IP Group due
to low QoE (e.g., low MOS), despite connectivity.
SBC General
'Classify By Proxy Set'
classify-by-proxy-set
[IPGroup_ClassifyByProxySet]
Enables classification of incoming SIP dialogs
(INVITEs) to Server-type IP Groups based on Proxy Set
(assigned using the IPGroup_ProxySetName
parameter).
■ [0] Disable
■ [1] Enable = (Default) The device searches the
Proxy Sets table for a Proxy Set that is configured
with the same source IP address as that of the
incoming INVITE (if host name, then according to
the dynamically resolved IP address list). If such a
Proxy Set is found, the device classifies the INVITE
as belonging to the IP Group associated with the
Proxy Set.
Note:
■ The parameter is applicable only to Server-type IP
Groups.
- 350 -