AudioCodes E-SBC User Manual

CHAPTER18 Core Entities
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
■ The parameter overrides inbound message
manipulation rules that manipulate the host name in
Request-URI, To, and/or From SIP headers. If you
configure the parameter and you want to manipulate
the host name in any of these SIP headers, you must
apply your manipulation rule (Manipulation Set ID) to
the IP Group as an Outbound Message Manipulation
Set (see the IPGroup_OutboundManSet parameter),
when the IP Group is the destination of the call. If
you apply the Manipulation Set as an Inbound
Message Manipulation Set (see the IPGroup_
InboundManSet parameter), when the IP Group is
the source of the call, the manipulation rule is
overridden by the SIP Group Name parameter.
■ For the Gateway application: If the IP Group is of
User type, the parameter is used internally as a host
name in the Request-URI for Tel-to-IP initiated calls.
For example, if an incoming call from the device's
trunk is routed to a User-type IP Group, the device
first creates the Request-URI (<destination_
number>@<SIP Group Name>), and then it
searches the registration database for a match.
'Created By Routing Server'
[IPGroup_
CreatedByRoutingServer]
(Read-only) Indicates whether the IP Group was created
by a third-party routing server:
■ [0] No
■ [1] Yes
For more information on the third-party routing server
feature, see Centralized Third-Party Routing Server.
'Used By Routing Server'
used-by-routing-server
[IPGroup_UsedByRoutingServer]
Enables the IP Group to be used by a third-party routing
server for call routing decisions.
■ [0] Not Used (default)
■ [1] Used
For more information on the third-party routing server
feature, see Centralized Third-Party Routing Server.
'Proxy Set Connectivity'
show voip proxy sets
status
[IPGroup_ProxySetConnectivity]
(Read-only field) Displays the connectivity status with
Server-type IP Groups. As the Proxy Set defines the
address of the IP Group, the connectivity check (keep-
alive) by the device is done to this address.
■ "NA": Functionality is not applicable due to one of
the following:
✔ User-type IP Group.
✔ Server-type IP Group, but the keep-alive
mechanism of its' associated Proxy Set is
disabled.
■ "Not Connected": Keep-alive failure (i.e., no
connectivity with the IP Group).
- 349 -

AudioCodes E-SBC Specifications

General

Brand	AudioCodes
Model	E-SBC
Category	Gateway
Language	English