AudioCodes E-SBC User Manual

CHAPTER18 Core Entities
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
[IPGroup_SBCPSAPMode] ■ [0] Disable (default)
■ [1] Enable
For more information, see E9-1-1 Support for Microsoft
Skype for Business.
'Route Using Request URI Port'
use-requri-port
[IPGroup_
SBCRouteUsingRequestURIPort]
Enables the device to use the port indicated in the
Request-URI of the incoming message as the
destination port when routing the message to the IP
Group. The device uses the IP address (and not port)
that is configured for the Proxy Set associated with the
IP Group. The parameter thus allows the device to route
calls to the same server (IP Group), but different port.
■ [0] Disable = (Default) The port configured for the
associated Proxy Set is used as the destination port.
■ [1] Enable = The port indicated in the Request-URI
of the incoming message is used as the destination
port.
'Keep Original Call-ID'
sbc-keep-call-id
[IPGroup_
SBCKeepOriginalCallID]
Enables the device to use the same call identification
(SIP Call-ID header value) received in incoming
messages for the call identification in outgoing
messages. The call identification value is contained in
the SIP Call-ID header.
■ [0] No = (Default) The device creates a new Call-ID
value for the outgoing message.
■ [1] Yes = The device uses the same Call-ID value
received in the incoming message for the Call-ID in
the outgoing message.
Note: When the device sends an INVITE as a result of a
REFER/3xx termination, the device always creates a
new Call-ID value and ignores the parameter's settings.
'Dial Plan'
sbc-dial-plan-name
[IPGroup_SBCDialPlanName]
Assigns a Dial Plan to the IP Group. The device
searches the Dial Plan for a dial plan rule that matches
the prefix of the source number and if not found, for a rule
that matches the prefix of the destination number. If a
matching dial plan rule is found, the rule's tag is used in
the routing and/or manipulation processes as source
and/or destination tags.
To configure Dial Plans, see Configuring Dial Plans.
Note: For IP-to-IP Routing rules that are configured for
destination based on tags (i.e., 'Destination Type'
parameter configured to Destination Tag), the parameter
is applicable only to the source IP Group and the device
searches the Dial Plan for a dial plan rule that matches
the prefix of the destination number only. For more
information on routing based on destination tags, see
Using Dial Plan Tags for Routing Destinations.
- 356 -

AudioCodes E-SBC Specifications

General

Brand	AudioCodes
Model	E-SBC
Category	Gateway
Language	English