AudioCodes E-SBC User Manual

CHAPTER18 Core Entities
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
'SBC IPv4 SIP
Interface'
sbcipv4-sip-int-
name
[ProxySet_
SBCIPv4SIPInterfaceN
ame]
Assigns an IPv4-based SIP Interface for SBC calls to the Proxy
Set.
Note:
■ At least one SIP Interface must be assigned to the Proxy Set.
■ The parameter appears only if you have configured a network
interface with an IPv4 address in the IP Interfaces table (see
Configuring IP Network Interfaces).
■ To configure SIP Interfaces, see Configuring SIP Interfaces.
'Gateway IPv6 SIP
Interface'
gwipv6-sip-int-
name
[ProxySet_
GWIPv6SIPInterfaceN
ame]
Assigns an IPv6-based SIP Interface for Gateway calls to the
Proxy Set.
Note:
■ At least one SIP Interface must be assigned to the Proxy Set.
■ The parameter appears only if you have configured a network
interface with an IPv6 address in the IP Interfaces table.
'SBC IPv6 SIP
Interface'
sbcipv6-sip-int-
name
[ProxySet_
SBCIPv6SIPInterfaceN
ame]
Assigns an IPv6-based SIP Interface for SBC calls to the Proxy
Set.
Note:
■ At least one SIP Interface must be assigned to the Proxy Set.
■ The parameter appears only if you have configured a network
interface with an IPv6 address in the IP Interfaces table.
'TLS Context Name'
tls-context-name
[ProxySet_
TLSContextName]
Assigns a TLS Context (SSL/TLS certificate) to the Proxy Set.
By default, no TLS Context is assigned. If you assign a TLS
Context, the TLS Context is used as follows:
■ Incoming calls: If the 'Transport Type' parameter (in this table)
is set to TLS and the incoming call is successfully classified to
an IP Group based on the Proxy Set, this TLS Context is used.
If the 'Transport Type' parameter is set to UDP or classification
to this Proxy Set fails, the TLS Context is not used. Instead,
the device uses the TLS Context configured for the SIP
Interface (see Configuring SIP Interfaces) used for the call;
otherwise, the default TLS Context (ID 0) is used.
■ Outgoing calls: If the 'Transport Type' parameter is set to TLS
and the outgoing call is sent to an IP Group that is associated
with this Proxy Set, this TLS Context is used. Instead, the
device uses the TLS Context configured for the SIP Interface
used for the call; otherwise, the default TLS Context (ID 0) is
used. If the 'Transport Type' parameter is set to UDP, the
device uses UDP to communicate with the proxy and no TLS
Context is used.
To configure TLS Contexts, see Configuring TLS Certificate
Contexts.
Keep Alive
- 369 -

AudioCodes E-SBC Specifications

General

Brand	AudioCodes
Model	E-SBC
Category	Gateway
Language	English