To Next Page

To Previous Page

CHAPTER21 SIP Message Manipulation

Mediant 1000 Gateway & E-SBC | User's Manual

For a detailed description of supported regex syntax, refer to the Syntax for SIP

Message Manipulation Reference Guide

Pre-Parsing Manipulation is configured using two tables with "parent-child" relationship:

■ Pre-Parsing Manipulation Sets table ("parent"): Defines a descriptive name for the Pre-Parsing

Manipulation Set.

■ Pre-Parsing Manipulation Rules table ("child"): Defines the actual manipulation rule. You can

configure up to 10 rules per Pre-Parsing Manipulation Set.

The following procedure describes how to configure Pre-Parsing Manipulation Sets through the

Web interface. You can also configure it through other management platforms:

■ Pre-Parsing Manipulation Sets table: ini file [PreParsingManipulationSets] or CLI

(configure voip > message pre-parsing-manip-sets)

■ Pre-Parsing Manipulation Rules table: ini file [PreParsingManipulationRules] or CLI

(configure voip > message pre-parsing-manip-rules)

➢ To configure Pre-Parsing Manipulation Sets:

1. Open the Pre-Parsing Manipulation Sets table (Setup menu > Signaling & Media tab >

Message Manipulation folder > Pre-Parsing Manipulation Sets).

2. Click New; the following dialog box appears:

3. Configure a Pre-Parsing Manipulation Set name according to the parameters described in the

table below.

4. Click Apply.

Table 21-4: Pre-Parsing Manipulation Set Table Parameter Descriptions

Parameter Description

'Index'

[PreParsingManipulationSets_

Index]

Defines an index number for the new table row.

Note: Each row must be configured with a unique index.

'Name'

name

[PreParsingManipulationSets_

Name]

Defines a descriptive name, which is used when

associating the row in other tables.

The valid value is a string of up to 40 characters.

Note:

■ Each row must be configured with a unique name.

■ The parameter value cannot contain a forward slash (/).

- 520 -

AudioCodes E-SBC User Manual

Questions and Answers: