AudioCodes E-SBC User Manual

CHAPTER24 Trunk Groups
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
'Serving IP Group'
serving-ip-group
[TrunkGroupSettings_
ServingIPGroupName]
Assigns an IP Group to where the device sends INVITE messages
for calls received from the Trunk Group. The actual destination to
where the INVITE messages are sent is according to the Proxy Set
associated with the IP Group. The Request-URI host name in the
INVITE and REGISTER messages (except for 'Per Account'
registration modes) is set to the value of the 'SIP Group Name'
parameter configured in the IP Groups table (see Configuring IP
Groups on page344).
Note:
■ If the parameter is not configured, the INVITE messages are
sent to the default Proxy or according to the Tel-to-IP Routing
table (see Configuring Tel-to-IP Routing Rules).
■ If the PreferRouteTable parameter is set to 1 (see Configuring
Proxy and Registration Parameters), the routing rules in the Tel-
to-IP Routing table take precedence over the selected Serving
IP Group ID.
'MWI Interrogation
Type'
mwi-
interrogation-
type
[TrunkGroupSettings_
MWIInterrogationType]
Defines message waiting indication (MWI) QSIG-to-IP interworking
for interrogating MWI supplementary services.
■ [255] Not configured.
■ [0] None = Disables the feature.
■ [1] Use Activate Only = MWI Interrogation messages are not
sent and only "passively" responds to MWI Activate requests
from the PBX.
■ [2] Result Not Used = MWI Interrogation messages are sent,
but the result is not used. Instead, the device waits for MWI
Activate requests from the PBX.
■ [3] Use Result = MWI Interrogation messages are sent, its
results are used, and the MWI Activate requests are used. MWI
Activate requests are interworked to SIP NOTIFY MWI
messages. The SIP NOTIFY messages are sent to the IP Group
defined by the NotificationIPGroupID parameter.
Note:
■ The parameter is applicable only to digital interfaces.
■ The parameter appears in the table only if the VoiceMailInterface
parameter is set to 3 (QSIG) (see Configuring Voice Mail).
Status
'Admin State' (Read-only) Displays the administrators state:
■ "Locked": The Lock command has been chosen from the Action
drop-down button.
■ "Unlocked": The Unlock command has been chosen from the
Action drop-down button.
'Status' (Read-only) Displays the current status of the trunks/channels in the
Trunk Group:
- 580 -

AudioCodes E-SBC Specifications

General

Brand	AudioCodes
Model	E-SBC
Category	Gateway
Language	English