CHAPTER24 Trunk Groups
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
The "SipGroupName" in the Request-URI is configured in the IP
Groups table (see Configuring IP Groups).
Note:
â– If the parameter is not configured, the registration is performed
according to the global registration parameter,
ChannelSelectMode.
â– To enable Trunk Group registration, set the global parameter,
IsRegisterNeeded to 1. This is unnecessary for 'Per Account'
registration mode.
â– If the device is configured globally to register Per Endpoint and
an channel group includes four channels to register Per
Gateway, the device registers all channels except the first four
channels. The group of these four channels sends a single
registration request.
'Used By Routing
Server'
used-by-routing-
server
[TrunkGroupSettings_
UsedByRoutingServer]
Enables the use of the Trunk Group by a routing server for routing
decisions.
â– [0] Not Used (default)
â– [1] Used
For more information, see Centralized Third-Party Routing Server.
SIP Configuration
'Gateway Name'
gateway-name
[TrunkGroupSettings_
GatewayName]
Defines the host name for the SIP From header in INVITE
messages, and the From and To headers in REGISTER requests.
By default, no value is defined.
Note: If the parameter is not configured, the global parameter,
SIPGatewayName is used.
'Contact User'
contact-user
[TrunkGroupSettings_
ContactUser]
Defines the user part for the SIP Contact URI in INVITE messages,
and the From, To, and Contact headers in REGISTER requests.
The valid value is a string of up to 60 characters. By default, no
value is defined.
Note:
â– The parameter is applicable only if the 'Registration Mode'
parameter is configured to Per Account and registration based
on the Accounts table is successful.
â– If registration fails, the user part in the INVITE Contact header is
set to the source party number.
â– The 'Contact User' parameter in the Accounts table overrides
this parameter (see Configuring Registration Accounts).
- 579 -