AudioCodes E-SBC

CHAPTER34 Routing SBC
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
■ The parameter is applicable only if the 'Destination Type'
parameter is configured to Dest Address [1] or ENUM [3];
otherwise, the parameter is ignored.
■ When using domain names, enter the DNS server's IP address
or alternatively, define these names in the Internal DNS table
(see Configuring the Internal SRV Table).
■ To terminate SIP OPTIONS messages at the device (i.e., to
handle them locally), set the parameter to "internal".
'Destination Port'
dst-port
[IP2IPRouting_
DestPort]
Defines the destination port to where the call is sent.
'Destination Transport
Type'
dst-transport-
type
[IP2IPRouting_
DestTransportType]
Defines the transport layer type for sending the call.
■ [-1] = (Default) Not configured. The transport type is determined
by the SIPTransportType global parameter.
■ [0] UDP
■ [1] TCP
■ [2] TLS
'IP Group Set'
ipgroupset-name
[IP2IPRouting_
IPGroupSetName]
Assigns an IP Group Set to the routing rule. The device routes the
call to one of the IP Groups in the IP Group Set according to the
load-balancing policy configured for the IP Group Set. For more
information, see Configuring IP Group Sets.
Note: The parameter is applicable only if you configure the
'Destination Type' parameter to IP Group Set (above).
'Call Setup Rules Set
ID'
call-setup-
rules-set-id
[IP2IPRouting_
CallSetupRulesSetId]
Assigns a Call Setup Rule Set ID to the routing rule. The device
performs the Call Setup rules of this Set ID if the incoming call
matches the characteristics of this routing rule. The device routes
the call to the destination according to the routing rule's configured
action, only after it has performed the Call Setup rules.
To configure Call Setup rules, see Configuring Call Setup Rules.
'Group Policy'
group-policy
[IP2IPRouting_
GroupPolicy]
Defines whether the routing rule includes call forking.
■ [0] None = (Default) Call uses only this route (even if Forking
Group members are configured in the rows below it).
■ [1] Forking = Call uses this route and the routes of Forking
Group members, if configured (in the rows below it).
Note: Each Forking Group can contain up to 20 members. In other
words, up to 20 routing rules can be configured for the same Forking
Group.
'Cost Group'
cost-group
[IP2IPRouting_
CostGroup]
Assigns a Cost Group to the routing rule for determining the cost of
the call.
By default, no value is defined.
To configure Cost Groups, see Configuring Cost Groups.
Note:
- 784 -