AudioCodes E-SBC - Page 968

CHAPTER50 System Status
Mediant 1000 Gateway & E-SBC | User's Manual
Field Description
■ "Fax": Fax call
Call Establishment
Method
Mode of call:
■ "Normal": No early media during SIP session establishment (before
call accepted).
■ "EarlyMedia": Media sent (e.g., announcements) before call
accepted by called party.
DTMF Selected
Method for Tx/Rx
DTMF Transport method used for the call. For configuring the transport
method, see Configuring DTMF Transport Types.
Basic
Channel Identifier: Channel identifier number.
Status Status of port:
■ "Inactive": No call
■ "Active": Active call
Call ID See above.
Endpoint ID ID of endpoint:
■ "Not Available"
Call Duration Call duration (in seconds) from when call was established.
Call Type Type of call:
■ "Voice": Voice call
■ "Fax": Fax call
Call Destination IP address of called party.
Coder Coder type used for the call.
Last Current Dis-
connect Duration
Duration of the disconnect signal.
Note: The parameter is applicable only to analog interfaces.
Line Current Line current (in mA).
Note: The parameter is applicable only to analog interfaces.
Line Voltage Line voltage (in V).
Note: The parameter is applicable only to analog interfaces.
Hook Status of phone:
■ "0": On hook
■ "1": Off hook
Note: The parameter is applicable only to analog interfaces.
Ring Status of ringing:
■ "0": Off
■ "1": On
Note: The parameter is applicable only to analog interfaces.
- 930 -