AudioCodes Mediant 8000 - Figure 17-1: Using Putty for RS-232 Serial Connections; Table 17-1: RS-232 Serial Connection Properties

Installation & Operation Manual 110 Document # LTRT-92224
Mediant 8000
 To connect to the CLI via an RS-232 serial console:
1. Connect the PC or RS-232 Console Terminal via the appropriate RS-232 cable to
either the SC’s RS-232 serial port or the serial port on the SA/RTM.
2. If you are using a PC, run the terminal client software and choose the serial port
where the RS-232 cable is connected.
Figure
17-1: Using PuTTY for RS-232 Serial Connections
3. Configure the serial connection properties as follows:
Table
17-1: RS-232 Serial Connection Properties
Property Value
Bits per second 9600
Data bits 8
Parity None
Stop bits 1
Flow control None