AudioCodes Mediant 8000 - Performing Basic Configuration of the Mediant 8000 Software on the SC Board to Operate as the Active Board

Version 6.6 147 October 2014
Installation & Operation Manual 21. Software Installation and Basic Configuration
21.2.1 Performing Basic Configuration of the Mediant 8000 Software
on the SC board to Operate as the Active Board
The following configuration should be performed on the SC board to operate as the
Active board (in Slot 1) in the following cases:

When the Mediant 8000 is installed in the customer premises for the 1
st
time and
its pre-installed software version matches the version used by the customer.

When the Mediant 8000 is moved to the new IP network segment (and IP
addresses of SC boards must be changed).

When the Mediant 8000's Operational mode is changed from non-secure to
secure mode (or vice versa)
 To perform the basic configuration of the Mediant 8000 software on the SC
board to operate as the Active board (in Slot 1):
1. Connect to the CLI interface on the SC board to operate as the Active board (in
Slot 1). For more information, see Section 'Command Line Interface' on page
107.
2. Login as user root. For more information, see Section 'Logging in as a Root User'
on page 115.
3. At the prompt, type install and press Enter.
4. Choose option 3.
client238::~# install
Found uncompressed Media Gateway installation package...
Verify installation package integrity...
SC Software Installation & Basic Configuration
1 - Change network configuration.
2 - Install the software.
3 - Change basic configuration.
4 - Copy basic configuration from Active SC.
5 - Uninstall the software.
0 - Quit.
Choose (0-5) : 3
System Configuration
Keyboard shortcuts:
ENTER - leave the default parameter value as is
\ - return to the previous parameter
Ctrl-C - abort the configuration script