AudioCodes Mediant 8000 - 39 Configuring the Media Settings

Version 6.6 527 October 2014
Installation & Operation Manual 39. Configuring the Media Settings
39 Configuring the Media Settings
Media Settings define different aspects of the media packetization performed by the
Mediant 8000 when transferring the calls over the IP network.
 To configure the Media Settings:
1. Click
to access the Media Gateway status screen.
2. Select the desired Media Gateway board.
3. In the Navigation pane, select Media and then in the configuration pane, click
Media Settings; the Media Settings screen is displayed.
4. Configure Media parameters as described below.
Table 39-1: Media Gateway Board's Voice Settings
Parameter Name Type Provisioning Type Description
Voice Volume Integer
-32 – 31
Instant Defines the Voice Gain
Control (volume).
PCM Input Gain Integer
-31 – 31
Instant Defines the PCM input
gain.
RFC2833
Receive Payload Type
Integer 96-127 Instant Defines the RFC 2833
Receive Relay RTP
Payload type.
RFC2833
Transmit Payload Type
Integer
96-127
Instant Defines the RFC 2833
Transmit Relay RTP
Payload type.
Voice Stream Upload
Method
Enum
Post, Put
Online Defines the voice
stream upload method.
Voice Streaming Enum
Disabled, Enabled
Online Enables voice
streaming over NFS
protocol. NFS allows for
a richer set of
functionalities, including
skip forward, skip
backward, pause and
continue operations.
Applicable mainly to the
Media Server
application.
Voice Volume Integer
-32 – 31
Instant Defines the Voice gain
control (in decibels).
This parameter sets the
level for the transmitted
(IP-to-PSTN) signal.