AudioCodes Mediant 8000 - A.2 Example 2: Three Subnets, VLAN Tags, One Physical Interface

Version 6.6 885 October 2014
Installation & Operation Manual A. Examples of IP Network Connectivity Configuration
A.2 Example 2: Three Subnets, VLAN Tags, One
Physical Interface
This example describes a complex configuration of an IP networking subsystem,
where the dedicated IP network segment (subnets) are used for transmitting
management (OAM), call control and media traffic. Subnets are separated via the use
of tagged VLANs and the Mediant 8000 is connected to all of them via a single
physical interface.
Figure
A-2: Network Example 2 : Three Subnets, VLAN Tags, One Physical Interface
 To configure the Mediant 8000 for a specific network setup:
1. Configure the basic IP network parameters of the SC boards as described in
'Configuring the Basic IP Network Parameters of the SC Boards' on page 117.
You will be prompted for the following parameters:
• IP Address – enter the IP address allocated for the specific SC board in the
OAM subnet, e.g. 10.8.1.11 for the SC board in Slot 1 and 10.8.1.12 for the
SC board in Slot 2
• Subnet Mask – enter the Subnet Mask of the OAM Subnet, e.g. 255.255.0.0
• Default Gateway – enter the IP address of the Default Gateway in the OAM
Subnet, e.g. 10.8.0.1
Perform the basic IP network configuration on both SC boards located in slots 1
and 2 respectively. Ensure to provide the same Subnet Mask and Default
Gateway on both SC boards.