Version 6.6 307 October 2014
Installation & Operation Manual 33. Configuring Security Settings
33.2.1 Enabling Secure Operation Mode
Note: The following procedures apply to SC Rev.1 boards (using the Solaris OS)
only. Secure Mode is automatically enabled for SC Rev.2 boards (using the Linux
OS).
The Media Gateway software must be stopped on both SC boards prior to changing
the Secure Operation Mode configuration.
To enable Secure Operation Mode:
1. Connect to the CLI interface on both SC boards. Use SSH protocol (and not
Telnet) when connecting via the IP network. For more information, see Section
'The Command Line Interface (CLI)' on page 107
2. Login as root user. For more information, see Section 'Logging in as a Root User'
on page 115.
3. To stop Media Gateway software on both SC boards, on each SC board, at the
prompt, type tools sc dn and press Enter. When prompted to confirm this
command type y and press Enter.
client238::~# tools sc dn
STOP SC SOFTWARE
Stop SC software? ([y]/n) : y
>>> Stop watchdog process...
>>> Wait for application to stop...
4. Perform basic configuration of the Media Gateway software on the SC board in
Slot 1, as described in 'Performing Basic Configuration of the Mediant 8000
Software on the SC board to Operate as the Active Board' on page 147. At the
Enable Security prompt, choose 1.
5. Perform basic configuration of the Media Gateway software on SC board in Slot
2, as described in 'Performing Basic Configuration of the Mediant 8000 Software
on the SC Board to Operate as the Standby Board' on page 150.
6. Reboot both SC boards.
To Next Page
Loading...
