Version 6.6 153 October 2014
Installation & Operation Manual 21. Software Installation and Basic Configuration
21.3 Starting Mediant 8000 Software
Mediant 8000 software is automatically started after both SC boards are rebooted.
In the default configuration, the SC board in Slot 1 operates as the Active SC board
and performs all maintenance and configuration tasks, while the SC board in Slot 2
operates as the Standby SC board and provides redundancy in case of a failure of the
SC board in Slot 1.
To verify that Mediant 8000 software is up and running on specific SC board:
1. Connect to the CLI interface on the specific SC board. For more information, refer
to 'Command Line Interface' on page 107.
2. Login as a regular CLI user (e.g. acladmin). For more information, refer to
'Logging into Command Line Interface' on page 115.
3. At the prompt, type tools sc p command. A list of SC software processes
indicates that software is up and running.
client241::~# tools sc p
LIST OF SC SOFTWARE PROCESSES
29510 tg_watch /Project/bin/exe/tg_watchdog
2185 tg_radiu tg_radius
2184 tg_xfer tg_xfer
2183 tg_syslo tg_syslog
2181 tg_core tg_core
2180 tg_tftp tg_tftp
2179 tg_bootp tg_bootp
2178 tg_tpncp tg_tpncpif
2177 tg_sat tg_sat
2176 tg_hbg tg_hbg
2175 tg_hbm tg_hbm
If the SC software is not running, repeat the Mediant 8000 software installation or
basic re-configuration.
To Next Page
Loading...
