Installation & Operation Manual 412 Document # LTRT-92224
Mediant 8000
34.8 Performance Measurement Threshold Alarms
For each Historty PM, the user may customize a threshold value. When the PM value
exceeds the high threshold, a PM Threshold Alarm is generated and reported to the
EMS and other SNMP managers. When the PM value drops below the low threshold
value, the corresponding alarm is cleared.
Use PM Threshold alarms to monitor mission-critical performance measurement and
receive immediate indication when a specific problem (indicated by a change in
corresponding PM value) occurs.
To configure PM Threshold Alarms:
1. Click
to access the Media Gateway status screen.
2. In the toolbar, click Performance.
3. In the Performance pane, select Threshold Alarms; the Threshold Alarms list is
displayed.
4. Use the
or buttons to add or remove entries.
5. When a new entry is added, the Threshold Alarm Parameters screen is
displayed.
6. In the Threshold Alarm Parameters screen, select the specific History PM and
configure its Threshold Alarm properties according to the table below.
To Next Page
Loading...
