Version 6.6 891 October 2014
Installation & Operation Manual B. Appendix - Configuring HSRP/VRRP
B.2 Configuring the Mediant 8000 Subnets
This section describes the CLI configuration actions required on the Media Gateway.
The Media Gateway CLI configuration is based on the following example data:
B.2.1 Subnet Configuration
OAM Subnet = 10.77.10.0/24
CONTROL Subnet = 10.77.11.0/24
MEDIA Subnet = 10.77.12.0./24
B.2.2 VLAN Configuration
OAN VLAN ID = 10
CONTROL VLAN ID = 11
MEDIA VLAN ID = 12
B.2.3 OAM Subnet Settings
It is presumed that the SC boards are already configured with the correct IP
addresses that belong to the OAM Subnet (10.77.10.0/24). If this is not the case,
update the configuration as described in 'Configuring IP Network Connectivity on SC
Boards' on page 195.
B.2.4 Interface Separation Settings
In the Media Gateway CLI, specify the following commands to configure the interface
mode:
modify Interfaces=0
B.2.5 VLAN Settings
In the Media Gateway CLI, specify the following commands to configure the
Media Gateway to work with three VLANs:
Note: moVlanTag is relevant only for the ES/6600 switch only.
To Next Page
Loading...
