AudioCodes Mediant 8000 - Table 26-5: TP Static Route Properties

Version 6.6 205 October 2014
Installation & Operation Manual 26. Connecting the Media Gateway to the IP Network
5. Use the or buttons to add or remove entries.
6. Select a specific row and then in the configuration pane, click TP Static Route
Settings; the Static Route Settings screen is displayed.
7. Configure TP Static Route parameters according to the table below.
8. Click the Maintenance icon
and select Unlock to activate the configuration.
Table 26-5: TP Static Route Properties
Parameter Name Type
Provisioning
Type
Description
Network Subnet Integer
0-10
Instant Defines the Network Subnet to which the
specific static route applies.
Destination IP
Address
String
Up to 40 chars.
Instant Defines the IP Address of the destination
entity.
Destination
Prefix Length
Integer
0-128
Instant Defines the Prefix Length of the
destination entity (for IPv4 addresses this
is equivalent to subnet mask).
When the Mediant 8000 wishes to send an
IP packet, it compares the packet's
destination address with the Destination IP
Address of each available static route
using a Destination Prefix Length for XOR
operation on both. If a match is found, the
packet will be sent to the static route's
Gateway IP Address.
Gateway IP
Address
String
Up to 40 chars.
Instant Defines the Gateway IP Address to which
packets to the destination entity will be
routed.
Comment String
Up to 200 chars.
Instant Defines the user-defined comment for
specific static route.