Installation & Operation Manual 82 Document # LTRT-92224
Mediant 8000
13.2.2 ES-2 LEDs
The ES-2 Ethernet Switch board has LED indicators on its front panel that indicate the
status of the board and its Ethernet Ports.
Table
13-4: ES-2 Board Status Led Indicators
LED Description Color Code Remarks
ACT
Off Currently not in use
FAIL Indicates the fault condition
on the board
Off Normal state
Red Fault condition is detected
Port Activity Indicates the activity status for
each of the 24 available
Ethernet Ports. See Section
'ES-2 Physical Slots to
Ethernet Port Mapping' below
to determine where the
specific Ethernet Port is
connected.
Green Port is connected
Off Port is disconnected
Flashing Green Activity on port (transmit or
receive)
Port Speed Indicates speed for each of
the 24 available Ethernet
Ports.
Yellow Port operates at 1000 Mbps
speed
Off Port operates at 10 or 100
Mbps speed
PWR Power status Off Power is not supplied to the
board
Green Power is received (normal
operation)
HOT SWAP Indicates board readiness for
extraction from the chassis
Off Normal state
Blue Board is ready for extraction
(latches are open)
To Next Page
Loading...
