Version 6.6 289 October 2014
Installation & Operation Manual 31. Configuring the MGCP/MEGACO Protocols
31.8.4 Configuring Additional MGCP/MEGACO Settings
This section describes how to configure additional MGCP/MEGACO Settings.
To configure additional MGCP/MEGACO Settings:
1. Click
to access the Media Gateway status screen.
2. Select the Media Gateway board.
3. In the Navigation pane, select Call Control and then in the configuration pane,
click Call Control Settings; the Call Control Settings screen is displayed.
4. Configure the additional MEGACO parameters as described in the table below.
Table
31-7: Media Gateway Board’s Call Control Parameters
Parameter Name Type
Provisioning
Type
Description
Board FQDN String
Up to 40 chars
Online Defines the FQDN name of the Media
Gateway board.
If the FQDN name is empty or equals "none",
the IP address of the Media Gateway board
surrounded by square brackets is used as
the domain name when constructing
MEGACO/MGCP messages. Otherwise the
FQDN name is used instead.
MGC Group Integer
-1 – 14
Online Defines Media Gateway Controller (MGC) to
which this board is associated. Value -1 is
used when the MEGACO/MGCP call control
protocols are not used for specific board –
e.g. in case of SIP application.
Control Protocol Enum
None,
MEGACO,
MGCP
Read-Only Indicates the call control protocol of the
Media Gateway Controller associated with
the specific board.
Call Control
Compatibility
Profile
Integer
1 –
2147483647
Online Defines the Call Control compatibility profile.
To Next Page
Loading...
