Version 6.6 407 October 2014
Installation & Operation Manual 34. Performance Measurements
6. Click the Parameters button. The MG Monitoring (RT) window is displayed.
Figure
34-6: MG Monitoring Window
Each parameter is measured using either Gauges or Counters. Gauges are
indicated by
and Counters are indicated by . For each PM query, if you
selected the Graph view then you cannot select parameters measured by both
Gauges and Counters.
7. Select the parameters group for which you wish to display performance
measurements (e.g., MG IP).
All parameters for the selected Parameter Group are displayed.
8. Check the desired parameters from the Parameter Group. You may select up to 5
parameters in the same entity (select a total of 10 parameters) or compare
parameters over different entities (e.g. over different trunks or boards).
9. Click OK button to return to the Real-Time Performance Measurement Display
window.
10. In the Real-Time Performance Measurement Display window, choose polling
interval and click the Start Polling button
to start polling.
To Next Page
Loading...
