Installation & Operation Manual 634 Document # LTRT-92224
Mediant 8000
The following steps should be performed to configure LCR:
1. Routing Rule Groups Table - Enable LCR feature and configure the average call
duration and default connection cost.
2. Cost Group Table - Configuring Cost Groups
3. Time Band Table - Configuring Time Bands for Cost Groups
4. Tel to IP / Outbound Table - Assign Cost Groups to outbound IP routing or IPtoIP
routing rules.
40.13.1 Configuring the Routing Rule Groups Table
This section describes how to configure the routing rule groups table.
To configure the Routing Rule Groups Table:
1. Click
to access the Media Gateway status screen.
2. Select the desired SIP board.
3. In the Navigation Pane, select SIP
SIP General Least Cost Routing
Routing Rule Groups; the Routing Rule Groups list is displayed.
4. Use the
or buttons to add or remove entries. Note – only one can be
added.
5. Select a specific row and in the Configuration pane, click SIP Routing Rule
Group Frame; the SIP Routing Rule Groups screen is displayed.
6. Configure SIP Routing Rule Gr
oups parameters according to the table Routing
Rule Groups Parameters' below.
7. Click the Maintenance icon
and select Unlock to activate the configuration.
Routing Rule Groups Parameters
Parameter
Name
Type
Provisioning
Type
Description
LCR Enable Enum
Disabled, Enabled
Instant Enables The Lcr Feature.
Average Call
Length
Integer
0-30000
Instant Defines The Average Call Duration (in
Minutes) And Is Used To Calculate The
Variable Portion Of The Call Cost.
Default Cost Enum
Lowestcost,
Highestcost
Instant Determines whether routing rules Routing
table without an assigned Cost Group are
considered a higher cost or lower cost route
compared to other matched routing rules that
are assigned Cost Groups.
To Next Page
Loading...
