AudioCodes Mediant 8000 User Manual

Version 6.6 231 October 2014
Installation & Operation Manual 27. Working with the SC Boards
27.7 Installing the Linux OS on the SC Rev.2 Board
The SC Rev.2 boards use a special version of the Linux operating system, provided
by AudioCodes and configured for optimal Mediant 8000 hardware and software
performance. For a typical SC board that is preinstalled with a correct version of the
Linux OS there is no need to re-install it.
Note: When it becomes necessary to re-install the Linux OS on SC boards, it is
important to use the Linux OS installation image provided by AudioCodes.
27.7.1 Verifying the Current Version of the Linux OS on the SC
Board
Version 6.6 of the Mediant 8000 software requires the Linux OS version 5.3 or later.
 To access the current version of the Linux™OS:
1. Connect to the SC board's CLI interface. For more information, see Section
'Command Line Interface' on page 107.
2. Login as root user. For more information, see Section 'Logging in as a Root User'
on page 115.
3. At the prompt, type cat /etc/version and press Enter. The current Linux OS
version is displayed.
4. Verify that the Linux OS version matches the version required by the specific
Mediant 8000 software.

AudioCodes Mediant 8000 Specifications

General

Brand	AudioCodes
Model	Mediant 8000
Category	Gateway
Language	English