Installation & Operation Manual 796 Document # LTRT-92224
Mediant 8000
6. Fasten the screws on the front plate of the board to secure the board to the
chassis and to ensure that the board has an earth connection to the chassis.
7. Using one of the Media Gateway Board Definition Methods discussed above, in
the EMS, define the board.
8. In the EMS, unlock the Media Gateway board that has been replaced. For more
information, see Section 'Working with the Media Gateway Boards' on page 245.
45.3.2 Replacing the Media Gateway Board's RTM module
The procedures for replacing the 6310/RTM and and 8410/RTM Media Gateway
Board's RTM modules are identical.
Caution Laser
Note for the 6310/RTM/STM1-OC3, the SONET/SDH interfaces contain a
Class 1 Laser device.
To remove the Media Gateway board's RTM from the chassis:
1. In the EMS, lock the Media Gateway board of the RTM to be replaced. For more
information see 'Working with the Media Gateway Boards' on page 245.
2. Remove all of the cables attached to the RTM.
3. Unfasten the screws on brackets at both ends of the panel that secure the board
to the chassis.
4. Press the red ejector buttons on the two black ejector/injector latches on both
ends.
5. Grasp the panel and ease the board out of the slot.
To insert a Media Gateway board's RTM into the chassis:
Caution Laser
Note for the 6310/RTM/STM1-OC3, the SONET/SDH interfaces contain a
Class 1 Laser device.
1. Hold the board Vertical.
2. With the black ejector/injector latches in the open (pulled out) position, insert the
board in the slot, aligning the board on the groves on each end.
3. Ease the board all the way into the slot until the ejector/injector latches touch the
chassis.
4. Press the two black ejector/injector latches on both ends inward, toward the
middle until you hear a click.
To Next Page
Loading...
