AudioCodes Mediant 8000 - Configuring IPSEC;IKE for Call Control and Signaling Interfaces (on TP Boards); Table 33-9: TP IPSEC Profile Parameters

Installation & Operation Manual 346 Document # LTRT-92224
Mediant 8000
33.11.4 Configuring IPSEC/IKE for Call Control and Signaling
Interfaces (on TP boards)
IPSEC/IKE protocols may be used to secure communication between Media Gateway
and MGCP/MEGACO Call Agents and/or SIGTRAN signaling gateways.
To configure IPSEC/IKE association for call control and singaling interfaces, the
following configuration entities (MOs) are used:

TP IPSEC Profile – represents a set of IPSEC/IKE associations on TP board (that
handle call control and signaling traffic); each profile may be attached to one or
multiple TP boards

TP IPSEC Rule – represents a single IPSEC/IKE association on TP board; up to
10 associations may be configured

TP IKE Proposal – represents an IKE proposal (a set of encryption and
authentication protocols) used by TP board; up to 4 proposals may be configured;
contrary to SC boards’ configuration, the same set of IKE proposals is used by all
TP IPSEC Rules.
 To add and configure TP IPSEC Profile:
1. Click
to access the Media Gateway status screen.
2. In the Navigation pane, select Security TP IPSEC Profiles; the TP IPSEC
Profiles list is displayed.
3. Use the
or buttons to add or remove entries.
4. Select a specific row and then in the configuration pane, click TP IPSEC Profile
Settings; the TP IPSEC Profile Settings screen is displayed.
5. Configure the TP IPSEC Profile parameters according to the table below.
Table
33-9: TP IPSEC Profile Parameters
Parameter Name Type
Provisioning
Type
Description
Profile Name String
Up to 80 chars
Instant Textual name for the IPSEC Profile,
enabling to identify it easily.
 To add and configure TP IPSEC Rule:
1. Select the TP IPSEC Profile that you wish to configure.
2. In the Navigation pane, select TP IPSEC Rules; the TP IPSEC Rules list is
displayed.
3. Use the
or buttons to add or remove entries.
4. Select a specific row and then in the configuration pane, click TP IPSEC Rule
Settings; the TP IPSEC Rule Settings screen is displayed.
5. Configure the TP IPSEC Rule parameters according to the table below.