Installation & Operation Manual 798 Document # LTRT-92224
Mediant 8000
45.4.1 Constraints for Adding Boards to the Mediant 8000 System
This section describes the constraints for adding boards to the Mediant 8000 system.
For more information, see 'Board Assembly Order' on page 87.
45.4.1.1 TP-6310 Boards
Slots 7 to 8 and 11 to 17 are used for provisioning up to 9 TP-6310 boards (including
the TP-6310 Redundant board in slot 17) according to the customer’s requirements.
The RTMs are located in the rear cage of the Mediant 8000 Media Gateway in the
slot.
In less than a full configuration, place boards from slot 17 to 11 and then 8 to 7,
adding boards from the highest slot number to the lowest slot number. Unused slots
must be covered using the appropriate blank panel.
45.4.1.2 TP-8410 Boards
Slots 4 and 7 and 11 to 15 are used for provisioning up to 7 TP-8410 boards (including
the TP-8410 Redundant board in slot 4) according to the customer’s requirements.
The RTMs are located in the rear cage of the Mediant 8000 Media Gateway in the
slot.
In less than a full configuration, place boards from slot 15 to 11 and then 7 and 4,
adding boards from the highest slot number to the lowest slot number. Unused slots
must be covered using the appropriate blank panel.
To Next Page
Loading...
