AudioCodes Mediant 8000 - Configuring AD-Based Routing Rules

Version 6.6 645 October 2014
Installation & Operation Manual 40. General SIP Configuration
Parameter
Name
Type
Provisioning
Type
Description
LDAP Private
NUM Attribute
Name
String
Default:
msRTCSIP-
PrivateLine
Instant
This attribute msRTCSIP-PrivateLine
represents user private line number in
Active Directory.
LDAP Private
key
String
Default:empty string
Instant if the Primary Key is configured, it uses
the defined string as a primary key
instead of the one defined in
LDAPPBXNumAttributeName. It requests
the attributes which are described below.
LDAP
secondary key
String
Default:empty string
Instant If the primary query is not found in the
AD and the Secondary Key is configured,
it does a second query for the destination
number using a second AD attribute key
name, configured by the
LDAPSecondaryKey parameter
40.15.4 Configuring AD-Based Routing Rules
The procedure below describes how to configure Tel-to-IP routing based on LDAP
queries.
 To configure LDAP-based Tel-to-IP routing for Lync Server 2010:
1. Configure the LDAP server parameters, as described in .'Configuring LDAP
Server Parameters' on page 640.
2. Configure the AD attribute names used in the LDAP query.
a. Configure the LDAP attribute names as desired.
3. For the Gateway/IP-to-IP application: Configure AD-based Tel-to-IP routing rules:
a. Select the relevant VoIP board, and then open the Tel to IP routing table
(SIP
GW/IP to IP Routing Telephone to IP / Outbound).
b. Configure query-result routing rules for each IP domain (private, PBX / IP
PBX, Lync / OCS clients, and mobile), using the LDAP keywords (case-
sensitive) for the prefix destination number:
Table
40-26: Destination Username Prefixes
AD Object Description
PRIVATE Private number
OCS Lync / OCS client number
PBX PBX / IP PBX number