AudioCodes Mediant 8000 - B Appendix - Configuring HSRP;VRRP

Version 6.6 889 October 2014
Installation & Operation Manual B. Appendix - Configuring HSRP/VRRP
B Appendix - Configuring HSRP/VRRP
This appendix describes how to configure the Media Gateway to operate with the
Cisco Hot Standby Routing Protocol (HSRP).
B.1 Overview
The appendix describes example procedures for configuring the Media Gateway and
the Cisco L3 switch network. The appendix also describes test failure scenarios. The
procedures described in section 'Configuring the User Environment (Cisco L3 switch)'
on page 893 are based on HSRP; however the same principals can also be applied to
VRRP.
The example described in this appendix is based on the following data:

1 Mediant 8000

3 Cisco L3 switch (3560)

3 Subnets

3 VLANs

No Physical Separation

Link Aggregation
Note: The above data represents an example configuration. Modify configuration
data according to your environment.