AudioCodes Mediant 8000 - Table 33-11: TP IKE Proposal Parameters

Installation & Operation Manual 348 Document # LTRT-92224
Mediant 8000
Parameter Name Type
Provisioning
Type
Description
IPSEC Lifetime
(kbytes)
Integer
0 –
2147483647
Online Defines the IPSEC SA Lifetime (in
kilobytes).
DPD Mode Enum
Disabled,
Periodic
Checks, On
Demand
Checks
Online Activates Dead Peer Detection (DPD) as
per RFC 3706.
 To add and configure the TP IKE Proposal:
1. Select the TP IPSEC Profile that you wish to configure.
2. In the Navigation pane, select TP IKE Proposals; the TP IKE Proposals list is
displayed.
3. Use the
or buttons to add or remove entries.
4. Select a specific row and then in the configuration pane, click TP IKE Proposal
Settings; the IKE Proposal Settings screen is displayed.
5. Configure the TP IKE Proposal parameters according to the table below.
Table
33-11: TP IKE Proposal Parameters
Parameter Name Type
Provisioning
Type
Description
Authentication Enum
MD5, SHA1
Online Defines the authentication algorithm for
IPSEC and IKE SAs.
Encryption Enum
DES, 3DES, AES
Online Defines the encryption algorithm for IPSEC
and IKE SAs.
DH Group Enum
ModP768,
ModP1024
Online Defines the Diffie Hellman group.
 To attach the TP IPSEC Profile to the TP board and activate the
configuration:
1. Click
the to access the Media Gateway status screen.
2. Select the desired Media Gateway board.
3. In the Actions bar, click Lock to stop the service on the Media Gateway board.
4. In the Navigation pane, select Security and then in the configuration pane, click
Security Settings; the Security Settings screen is displayed.