Version 6.6 747 October 2014
Installation & Operation Manual 43. Session Border Controller (SBC) Application
43.11.2 Configuring the SBC IP to IP Routing Table
The SBC IP to IP Routing table consists of the following two parts:
Matching Rules
Destination Rules
All calls that match all or any combination of the "matching rules" are subsequently
sent to the destination IP address or IP Group defined by the "destination rules".
For alternative routing, additional entries of the same prefixes can be configured.
To configure SBC IP to IP Routing:
1. Click the
button to access the Media Gateway status screen.
2. Select the SIP board.
3. In the Navigation pane, select SIP
SBC SBC Routing IP to IP Routing;
the SIP IP to IP Routing list is displayed.
4. Use the
or buttons to add or remove entries.
5. Select a specific row and in the Configuration pane, click SIP IP to IP Routing
Settings; the SIP IP to IP Routing Settings screen is displayed.
6. Configure SBC IP to IP Routing parameters according to the table 'SBC IP to IP
Routing Table Matching Rules' below.
7. Click the Maintenance icon
and select Unlock to activate the configuration.
Table 43-5: SBC IP to IP Routing Table "Matching Rules"
Parameter Name Type
Provisioning
Type
Description
Source IP Group Integer
0-9
Instant Defines the IP Group from where the call
originated.
Typically, this IP Group is determined by
the Classification process.
If this feature is not used (i.e., any IP
Group), set to 0 (Any).
Source
Username Prefix
String
Up to 20 chars
Instant Defines the prefix of the user part of the
incoming INVITE's source URI (usually the
From header).
To denote any source username prefix
leave the field empty or use asterisk (*)
symbol.
To Next Page
Loading...
