AudioCodes Mediant 8000 - Table 8-1: TP-6310 Board Status LED Indicators

Installation & Operation Manual 48 Document # LTRT-92224
Mediant 8000
Note: There is an unmarked pinhole on the front panel of the TP-6310 board. This
pinhole should never be used when the TP-6310 is inserted into the Mediant 8000
chassis.
The TP-6310 Media Gateway board has LED indicators on its front panel that are
used to indicate status of the board and of its PSTN interfaces. The Indication
provided via these LEDs is very brief and high-level. Use the EMS management
interface for obtaining detailed information about the status of the board and each of
its component.
Table
8-1: TP-6310 Board Status LED Indicators
Group LED # LED Label Color Description
ACT --- Not in use
PSTN
(for STM-1/OC3
configuration)
A,B Link Off No link
Green Working link OK
Yellow Protection link OK
Alrm Off Normal operation
Red Alarm detected on
the link
C Link --- Not in use
Alrm --- Not in use
PSTN
(for T3
configuration)
A,B,C Link Off No Link
Green T3 Synchronized
Yellow Remote AIarm
(RAI) detected on
link
Alrm Off Normal operation
Red Near End Alarm
(LOS, LFA or AIS)
detected on link
PWR Off Board Power is
down
Green Normal Operation
SWAP READY Off Normal Operation
Blue Board is ready to
be extracted from
the chassis (latch
is open)