AudioCodes Mediant 8000 - 15.5 Preparing the IP Network Connectivity

Installation & Operation Manual 96 Document # LTRT-92224
Mediant 8000
15.5 Preparing the IP Network Connectivity
The Mediant 8000 must be connected to the IP network for proper operation.
The Mediant 8000 may operate in different IP network topologies, including networks
with multiple VLANs and subnets. For more information, see Section 'Connecting the
Media Gateway to the IP Network' on page 178 and 'Appendix : Examples of IP
Network Connectivity Configuration' on page 877.
Verify the configuration of the IP network available on the site and ensure the
following:

Two fully-redundant Layer 3 Ethernet Switches or Routers are available (to be
connected to the two ES boards).

1GB Ethernet interfaces are used

Switches are interconnected by at least 1Gb Ethernet interface (when interface
separation is configured and media traffic is aggregated, 3Gb interconnection
may be required).